The Ministry of Transport is drafting the National Technical Regulation on automobiles, trailers and semi-trailers participating in road traffic. The regulation is expected to take effect from January 1, 2025.
According to the new standards on vehicle inspection, there are regulations on fire extinguishers as follows:
The method of checking this part is observation.
Evaluation criteria are as follows:
Have fire extinguishers as required.
Fire extinguisher is still in use.
However, this regulation notes: motor vehicles that do not meet this requirement will still be inspected and granted an Inspection Certificate according to regulations.
In addition to fire extinguisher standards, the standards have regulations on the body, cockpit, and cargo box as follows:
The test method is observation.
Evaluation criteria are as follows:
Correct type, securely installed.
No cracks, breaks, holes, rust, tears, or deformation.
No air from the engine or exhaust gas leaks into the cabin or cockpit.
Paint does not peel.
Platform, frame, steps.
Standards for horizontal and vertical beams are as follows:
Testing method: Observation, hammer testing, combined with hand shaking.
Evaluation criteria are as follows:
Install firmly.
No cracks, breaks, rust, or deformation
Floor standards are as follows:
The test method is observation.
Evaluation criteria are as follows:
Secure installation
No holes, tears, or rust.
The standards for steps up and down are as follows:
The testing method is observation combined with hand shaking.
Evaluation criteria are as follows:
Complete, firmly installed, no cracks or breaks.
Correct technical documentation
No rust or holes.
Regarding door, door lock and door handle standards as follows:
The testing method is to close, open the door and observe, combined with shaking by hand.
Evaluation criteria are as follows:
Complete, sturdy installation.
Complete with hinges, latches, no damage (2).
Close and open gently.
Door opens or locks normally; does not open by itself; closes completely.
Electrical wire standards (above) are as follows:
The inspection method is to check the electrical wires on the vehicle and in the engine compartment by observation combined with shaking by hand.
Evaluation criteria are as follows:
Install firmly.
The insulation is not damaged.
Install according to technical documentation, no traces of friction on moving parts.